background image

Monogram.

Specification Created 4/00

ZSC2000CWW - GE Monogram Built-In Advantium

Oven

Dimensions (in inches)

• These ovens may be installed directly into a wall
or wall oven cabinetry, 30" minimum width.

• The front surface of the oven will be nearly flush
with surrounding cabinetry doors.

• This oven can be installed over any GE single
electric built-in oven or a single GE electric built-in
warming drawer.

• This oven must be installed at least 36" above 
the floor.

IMPORTANT:

This oven is not approved for use

above another built-in Speedcook oven, side by
side or under the countertop installations.

• For personal safety, this oven cannot be installed
in a cabinet arrangement such as an island or
peninsula.

• Cabinets installed adjacent to wall ovens must
have an adhesion spec of at least 194°F tempera-
ture rating.

• Allow for clearance to adjacent corners, walls,
drawers, etc.

29-25/32"

15"

(Recessed

Portion)

21-7/8"

15-27/32"*

28-7/16"

R

Listed by
Underwriters
Laboratories

For answers to your Monogram,

®

GE Profile Performance Series,

GE Profile

or GE appliance questions, call 

GE Answer Center

®

service, 800.626.2000.

27/32"

14-1/8"

15/32"

27/32"

20-27/32"

11/16"

7/8"

13"

9/16"

Single Speedcook Installation

Product rating is 120/208 or 120/240 volt, 60 Hz, 30 Amps. This product must be connected to
a supply circuit of the proper voltage and frequency and protected by a time delay fuse or cir-
cuit breaker. The power supply should be brought to a separate 30 ampere branch circuit.
Wire size must conform to the requirements of the National Electric Code or the prevailing
local code.

Combined Speedcook and Wall Oven Installation:

When installed in combination with a GE single wall oven, use separate electrical
junction boxes,
OR,
Install a single junction box connected to 50 amp. supply circuit or properly rated
supply circuit.
• Refer to single oven installation instructions for electrical requirements of 

that product.

• These connections must be made by a qualified electrician. All electrical 

connections must meet National Electrical code or prevailing local codes.

Combined Speedcook and Warming Drawer installation:

When installing the Speedcook oven over a GE electric warming drawer, a separate
120V, 60Hz, properly grounded receptacle must be installed. See instructions packed
with the warming drawer.

Electrical Requirements

Installation Requirements

*Excludes Handle

Reviews: