Plenum
Disconnect
Light and
Thermostat
522-08W
522-08F
DISCONNECT POWER BEFORE SERVICING TO PREVENT
ELECTRICAL SHOCK HAZARD
IMPORTANT:
Follow these instructions completely. Procedure
will vary slightly for non-dispenser models.
Parts Included:
Drain pan assembly with ground wire
Bar of PermaGum
Orange jumper Wire, with female
bullet connector on one end and
stack terminal on opposite end
(not
required on models produced after
10/94).
250ml
squeeze bottle
Insulating styrofoam piece
for side wall
Plastic “Xmas Plug” ratchet
fastener
(not required on models
produced after 10/94).
Insulation pieces to cover entire
evaporator compartment
2 Wire ties
Prepare Freezer Compartment
■
■
1.
Lift to remove top grille panel frame. Set aside. Locate
and disconnect or cut the 2 drain tube clamps in the
compressor compartment.
■
■
2.
Remove ice bucket, icemaker, shelves and all materials
in the freezer compartment.
■
■
3.
Remove the rear
panel section
(plenum). Discon-
nect the wiring to
the light socket
and over-tempera-
ture thermostat if
present.
MONOGRAM FREEZER ICING KIT WR49X10021
INSTALLATION INSTRUCTIONS
522-08J
522-08E
522-08Y
522-08G
522-08D
LEFT
BACK
TOP
FRONT
EVAP ORIFICE
PERF
LINE
RIGHT
EVAPORATOR
PLATE
INSULATION
NOTCH
522-08H
REAR
TOP
FRONT
DRAIN TUBE CLAMPS (2)
COMPRESSOR
COMPARTMENT
DIVIDER
EVAPORATOR
DRAIN
TUBE
522-08L
COMPRESSOR
DRAIN PAN
Installation Instructions
Page 1 of 4
70836-00
