background image

Page 

1

 of 

4

 

 
 

                                                                          

www.generalspecialtiesmfg.com

 

208-265-5244 

UPM 3X 

 
 

 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 

 
 
 

A.

 

ALUMINUM RAILS

2” X 1

-

1/2” X 1/8” UNIVERSAL 

ALUMINUM T-SLOT EXTRUSION WITH   

CHAMFERED ENDS 
 

B.

 

CROSS PIECES

: 3" X 1-1/2" ALUMINUM ANGLE  

 

C.

 

CENTER TUBE

: 2" X 2" SQ. TUBE WITH 3" ROUND TUBE BUSHING   

 

D.

 

TEE SOCKET

: STEEL TEE SOCKET WITH SET BOLTS FOR  

ADJUSTMENT 

 
 

Note:

 Number of panels may vary, length of rail may vary. 

UPM 3X

 

Standard stock Tee socket sized 

for 4" schedule 40 or 80 Pipe 

 

 

REVISION: 

 

 

02.09.16 

Summary of Contents for UPM 3X

Page 1: ...XTRUSION WITH CHAMFERED ENDS B CROSS PIECES 3 X 1 1 2 ALUMINUM ANGLE C CENTER TUBE 2 X 2 SQ TUBE WITH 3 ROUND TUBE BUSHING D TEE SOCKET STEEL TEE SOCKET WITH SET BOLTS FOR ADJUSTMENT Note Number of panels may vary length of rail may vary UPM 3X Standard stock Tee socket sized for 4 schedule 40 or 80 Pipe REVISION 02 09 16 ...

Page 2: ...schedule 40 or 80 post Slide Center tube into top of Tee Socket with one of the flat square tube surfaces horizontal level Tighten down on 3 set bolts on Tee Socket Make sure center tube faces east west then tighten 2 square head set bolts on Tee Socket Loosely attach Crosspieces on Center tube using flat bars and bolts provided Attach aluminum panel Rails to Crosspieces with 3 8 bolts Lay first m...

Page 3: ...ave very loamy or loose sandy soil get the recommendation of a soil engineer or building department then you may have to seek a design for an alternative foundation construction For type and size of pole to install in concrete foundation refer to chart below General Specialties Recommendations for Pole Height and Dimension for Top of Pole Mounts We cannot guarantee a standard 1 67 safety factor if...

Page 4: ...ng hole location Number of panels may vary Instructions for Attaching Solar Panel to Mounting Rails Lay T Slot rails across the short axis of the panel as shown in Photo 1 Slide stainless bolts into T slot of rail and position so they are opposite to the mounting holes on the frame of the panel as shown in Photo 2 Then roll the rails over so the bolts slip into the holes on the panel frame Place t...

Reviews: