5 Rapid beeps
These beeps occur only once when you are attempting to activate the unit via your
remote control. If after pressing your remote control you get a series 5 beeps, pause, 5
beeps, pause without pressing the remote see the 5 beep error code document.
Do you currently have a Zombie lock connected to your system? If yes proceed to step 1.
If you have removed your Zombie Lock please follow step 3 instructions.
Step 1
Make sure all your lock wires are secure. Turn the system off, remove the red, black, and blue
wires from the control board. Inspect and replace the wires back into the terminals.Turn the system on
and test with your remote control. If the issue persists proceed to step 3.
Step 2
Check for binding at the closed position between the receiver lock pin and lock. If the pin is
resting against the lock draw bolt you will need to readjust your gate closed position. Please refer to your
installation manual for the automatic gate opener and the Zombie Lock Manual.
