MDE-2636D Canopy Kits (K35496 and K35498) for The Advantage® Series and Canopy Kit (K96632-02) for Encore® · September 2012
Page 1
Introduction
Purpose
This document provides instructions for assembling and installing Canopy Kits
[K35496 (for 48-inch wide frame)] and [K35498 (for 36-inch narrow frame)] for
The Advantage
®
Series units, and Canopy Kit (K96632-02) for Encore
®
units.
Table of Contents
Topic
Page
Assembling the Panels [T17232-GXXX (The Advantage Series Only)]
Assembling the Panels [M00781B001 (Encore Units Only)]
Attaching the Canopy Bracket [M00780B001PB0 (For The Advantage Series Only)]
Attaching the Canopy Bracket [M00780B001PB0 (For Encore Units Only)]
Installing the Assembled Canopy (The Advantage Series and Encore Units)
Required Tools
Following tools are required for the installation of the Canopy Kits (K35496 and K35498) for
The Advantage Series and Canopy Kit (K96632-02) for Encore units:
• 17 mm Socket and Open End Wrench
• 10 mm Socket and Open End Wrench
Required Reading
Before installing the equipment, the installer must read, understand, and follow:
• This Manual
• NFPA 30, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable federal, state, and local codes and regulations
Note: Failure to do so may adversely affect the safe use and operation of the equipment.
MDE-2636D
Canopy Kits (K35496 and K35498) for The Advantage
®
Series and Canopy Kit (K96632-02) for Encore
®
September 2012
