background image

-1-

D-TECT X REPEATER

GJD 397 Repeater

Package Contents

Package Contains: 

• 

1 x D-TECT X Repeater & 1A PSU in IP65 

Housing

• 

1 x Installation Manual 

Introduction

The D-Tect X Repeater can be used to extend the 

range of a D-Tect X detector, or to boost signal in a poor 

reception area.

D-Tect X Repeater

The D-Tect X Repeater must be placed within 500 

metres line of sight between the D-Tect X detector(s) 

and D-Tect X Receiver(s). The unit will repeat all signals 

from D-Tect X detectors within range and as such does 

not require any programming to function.

Specifications

Range

500m (line of sight)

Tamper Switches

Front and rear tamper switch-

es: case open and removal 

from wall

Wireless Frequency

868MHz

Current

23mA (12V nominal)

Operating Temperature

-10 to +50 Centigrade, 

Conformal coated electronics 

for increased stability

Housing

High impact, flame retardant, 

UV stabilised Polycarbonate

Protection Rating

IP55

Dimensions

W210mm x H180m x D79m

Weight

750grams NET, 880grams 

GROSS

Power Supply Module

The GJD Power Supply Module provides a 12 VDC 

output from a 230 VAC input that enables the D-Tect X 

Repeater to be conveniently installed with easy access 

to a mains supply.

Installation

• 

The Power Supply Module requires a 230 VAC-

supply on the LIVE input and a neutral on the N 

connection.

• 

 An EARTH connection is also provided for the 

termination of the earth conductor. Ensure this 

connection is securely made.

• 

Connect the positive and negative terminals of the 

12 VDC output to the corresponding inputs of the 

D-Tect X Repeater.

IMPORTANT SAFETY REQUIREMENTS

• 

The Power Supply Module MUST be installed and 

maintained by suitably qualified engineers and the 

installation MUST comply with all relevant code of 

practice and regulations.

• 

 All mains supplies to the module MUST be via a 

Residual Current Device (RDC) and an overload 

protection device.

• 

All mains supplies to the module MUST be 

disconnected before removing the cover.

Specifications

Mains Supply Input

230 VAC, 50 Hz

12 VDC Output

12 VDC, 1A

5 VDC Output

5 VDC, 0.1A

Operating Temperature

-10 - +50 degrees centigrade

Reviews: