750 W Lake Cook Rd, Suite 480 | Buffalo Grove, IL 60089 | Ph: 847.495.4700
w w w . G e t X c l u d e r . c o m
Installation Instructions:
1.
Sweep should be mounted on the outside of the door.
2.
Measure door and cut sweep to fit. This step may not be necessary. If
cutting is required, cut excess material from the end of the sweep that does
not have the pre-installed guards.
3.
When cutting the sweep, best results are obtained by first using a hacksaw
to cut through the aluminum retainer and then sturdy shears to cut the
rubber and Xcluder filling. NOTE: Sawing through the Xcluder filling is not
recommended.
4.
Using the end of the sweep with the metal end guards already installed as a
model, install the end guards on the opposite end of the sweep, as follows:
a. Using a standard screwdriver, gently separate Xcluder filling from
the metal mesh in a ½” wide x ¾” deep section at the middle of both
faces on the sweep.
b. Place an end clip on it’s side on a hard, flat, sturdy surface.
c. Hold the end guard and drive the standard screwdriver blade into
the end guard at the looped end. This will separate the open end.
d. Place the opened end guard, flat side out, onto one of the edges of
the door sweep in the location the Xcluder filling was separated from
the metal mesh.
e. Holding the end guard in place with your thumb, pull the screwdriver
from the end guard.
f. Using the screwdriver handle, tap the Xcluder end guard flush with
the edge of the door sweep.
g.
Repeat steps a-f for the remaining unguarded door sweep edge.
USE CARE WHEN HANDLING AND CUTTING. ALWAYS
WEAR GLOVES AND SAFETY GLASSES
Xcluder® Pest Control Door Sweep Installation Instructions
Use for Part #s: 162600, 162602, 162604, 162608, 162620, 162622, 162624, 162628, 162638, 162640
Thank you for your purchase of an
Xcluder Pest Control Door
Sweep
, the best way to close the door on unwanted pests.
Tools Required:
1.
Phillips head screwdriver
2.
1/4” nut driver — Commercial Sweeps Only
(Part #’s: 162602, 162622, 162640)
3.
Drill and 7/64” bit
4.
Hacksaw –
only needed if the sweep needs to be trimmed to fit
5.
Sturdy shears -
only needed if the sweep needs to be trimmed to fit
4a-1
4a-2
4c
4d
4f
2
1
Pre-installed End Guard
DO NOT TRIM THIS END
Version—BG2, 1-11-18
