The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is
not responsible for any incorrect information contained herein and urges any buyer or potential buyer to test the product prior to making a purchase.
Graphics One, 824 W. Ahwanee Avenue. Sunnyvale, CA 94085, USA Tel: 818-260-9591, Email: sales@graphicsone.com, Website: www.graphicsone.com ©Copyright 2017
Graphics One, GO (Graphics One), are trademarks of Graphics One. All other trademarks are properties of their respective companies.
+1-818-260-9591 • sales@graphicsone.com • www.graphicsone.com
SUPPORT
GOTEK
TB-PR 005-V2
PAGE 1
GO ET-15000 SP Film Setup
ScreenMate™ Film Installation on ET-15000
This technical bulletin describes the procedure on how to print film with the GO ET-15000 printer.
1. With the pinter, you will receive a box of film and the ScreenMate™ Film Guide. The ScreenMate™ Film Guide is
needed so the media sensor will detect the film for imag-
ing.
Prepare one sheet of ScreenMate™ Film and
the
ScreenMate™ Film Guide. The ScreenMate™ Film Guide is
the white
media
which is included with each box of film.
2. Prepare one sheet of Screenmate™ Film and the
ScreenMate™ Film Guide. The ScreenMate™ Film must
have the printing side facing up.
3. Insert one of the corners of the ScreenMate™ Film
on the Film Guide.
