Golden wheel CS-471, Instruction Manual

GOLDEN WHEEL

No.000001

Please read this Instruction Manual
carefully before using the unit in or
-der to get the most out of it and
to enjoy using it for a long time.
Please keep this Instraction Manual
at hand taking care not to lose it.

BEFORE OPERATION

1. Do not the machine even for trial before lubricating it.

2. Confirm that the voltage and phase (single or 3-phase) are correct by checking them againt the

   ratings shown on the nameplate. 

3. When running your machine for the first time after the set-up, check the rotational direction of

   the handwheel.

   ・ Turn ON the power switch. Run the machine at a low speed while checking the rotational 

      direction of the handwheel.(The handwheel should turn counterclockwise as observed from the

      handwheel side.)

4. For the first month, run the machine at a speed of 600 s.p.m. or less.

CAUTIONS IN OPERATION

1. Keep your hands away from the needle when you turn ON the power switch or while the machine 

   is operating.

2. During operation, be careful not to allow your or any other person's head or fingers to come close

   to the handwheel, V belt, bobbin winder or moter. Also, do not place anything close to them.

3. Do not run the machine with the finger guard, belt cover or any other protectors removed.

   Eye guard is option.

4. Be sure to turn OFF the power switch and confirm that the motor is completely stopped before

   removing the V belt.

5. Never remove the sewing machine from the table with the moter removed from the table.

SPECIFICATIONS

1] INSTALLING THE THREAD STAND

    Assemble the thread stand, and install it to the right
    -hand side of the far side of the table with screws
　　①　(at 3 places).

CS-471

1-NEEDLE,TOP & BOTTOM FEED, LONG CYLINDER BED,
LOCKSTITCH MACHINE FOR EZTRA HEAVY-WEIGHT
MATERIALS WITH A SEMI-ROTARY LARGE-CAPACITY
SHUTTLE

INSTRUCTION MANUAL

Usage

Pouches, bags, shoes, bag handles,

Needle to used

Schmetz 794Nm230

safty belts, etc.

Needle system

Nm130～Nm280

Sewing speed

Max.800s.p.m.

Thread

#00～#8

Stitch length

Max.11mm

Stitch adjusting method

Lever nut type

Lift of presser foot

Hand lifter      12mm

Lubrication method

Hand oiling 

Knee lifter      20mm

Motor to be used

3-phase/single phase 400W

Thread take-up lever

Cam-type thread take-up lever

clutch motor(4P)

Needle bar stroke

56mm

- 1 -