background image

3A2852B

Operation

Quick Set-up Guide for TrueCoat Plus II
BackPack Sprayer

- For use with Graco hand-held sprayers (except Fine-Finish sprayers) -

- For portable spray applications of water-based and oil-based (mineral spirit-type) 

architectural paints and coatings only -

- Not approved for use in explosive atmosphere locations -

Model 24N812

Maximum Working Pressure 12 psi (0.83 bar, 0.083 MPa)

IMPORTANT SAFETY INSTRUCTIONS

For complete warnings and safety 
instructions, see sprayer manual.

EN

ti16502b

WARNING

WARNING

WARNING

WARNING

FIRE AND EXPLOSION HAZARD

Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F 
(38° C). 

Do not use materials which state “FLAMMABLE” on the packaging. For more information about 

your material, request MSDS from distributor or retailer.

Use oil-based material outdoors or in a well-ventilated indoor area with a flow of fresh air.

Summary of Contents for TrueCoat Plus II 24N812

Page 1: ...ng Pressure 12 psi 0 83 bar 0 083 MPa IMPORTANT SAFETY INSTRUCTIONS For complete warnings and safety instructions see sprayer manual EN ti16502b WARNING WARNING WARNING WARNING FIRE AND EXPLOSION HAZARD Use only water based or oil based mineral spirit type materials with flash point greater than 100 F 38 C Do not use materials which state FLAMMABLE on the packaging For more information about your ...

Page 2: ...erials 2 Remove air compressor from reservoir lid 3 Open battery door on flat side of air compressor 4 Remove 9V alkaline battery and remove shipping seal from battery terminals 5 Pull battery connector out of air compressor 6 Connect battery and place inside air compressor 7 Replace battery door 8 Turn on power switch to test battery red LED light should turn on ti16510a ti17593a ti17825a ti17591...

Page 3: ...d be sure to align center of strainer with center of reser voir lid Install reservoir lid to reservoir and hand tighten 7 Thread suction hose nut S onto lid assembly and hand tighten Insert drain hose H onto lid assem bly barb and secure with clamp 8 Install sprayer battery or plug sprayer into a properly grounded outlet 9 Place reservoir on floor install and turn on air com pressor P Hold sprayer...

Page 4: ...ow pressurized Failure to properly depressurize system will result in material discharging from hose and possible injury Always turn off and slowly remove air compressor from lid assembly to depressurize system before removing Hose set from sprayer Hose set from lid Lid from reservoir ti16507a ti16521a ti15425a CAUTION ti16510a All written and visual data contained in this document reflects the la...

Reviews: