НСТРУКЦІЯ З ЕКСПЛУАТАЦІЇ
ГОТЕЛЬНОГО СЕЙФА SH.20.K.E
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ
ГОСТИНИЧНОГО СЕЙФА SH.20.K.E
OPERATING INSTRUCTIONS FOR THE
HOTEL SAFE SH.20.K.E
General information:
Predefined "user code":
1-2-3-4-5-6
The lock can be opened with a "user code" or with a key.
1. Opening the safe
1.1. Enter the user code, consisting of
3
to
6
characters (the code installed at the factory,
1-2-3-4-5-6
)
1.2. If the code is entered correctly, within 5 seconds the door of the safe will automatically open.
1.3. When entering the wrong code, a five-time signal will sound, "
Error
" will appear on the display.
After the 5th incorrect input of the code, the keypad lock is locked for 15 minutes. During the whole
time of blocking, the display "
HOLD
" is turned on (during this time the lock can not be opened even
by inputting the correct code).
Note
:
Each pressing of the keypad is confirmed by a one-time short buzzer and a display of the entered
value on the keyboard display. If the buttons are not pressed for 15 seconds, the device enters the
standby mode, which switches off the sound and light indication of the display. If an error is
entered while entering the code (before pressing the "
LOCK
" buttons), you can delete the entered
value by pressing the "
CLEAR
" button.
2. Closure of the safe
To close the safe is necessary (the safe is in the open state), close the door of the safe and press
it with hand - enter the user code, consisting of 3 ... 6 characters, each pressing of the keypad is
confirmed by a single short buzzer and indication of the value entered on the keyboard display. If
the code is entered correctly (the number of characters is no more than 6) within 5 seconds the
safe automatically closes.
3. Change the lock code
The user code changes when closing the safe and entering a new code, the previous code is
canceled.
4. Opening the safe with an emergency key.
4.1. Insert the key into the keyhole and turn it counterclockwise. The safe door will open.
4.2. Enter a new user code (3 to 6 characters) and press the "LOCK" button (while holding the emer-
gency key with your hand). New user code installed.
4.3. The new user code will be re-entered to close the bolt system.
EN
Contacts
PARITET - К, Ltd
40-U, Glybochytska str., Kiev, Ukraine, 04052
Tel.: +38 044 531-91-00
https://
paritet-k.com.ua
https://
griffonsafes.com
e-mail:
office@griffonsafes.com
Customer Service
3-B Nosovskyy shlyah str.,Nezhin,
Chernihiv region, Ukraine, 16610
Tel.: +38 04631 751-44
Tel.: +38 050 444-64-21
e-mail:
service@griffonsafes.com
