GuitarPCB SHO' Nuff Quick Start Manual Download

Page: 1 / 4

SHO’ Nuff v3

Build either the classic one knob version or the more functional, modern two knob version.

We have added a Master Volume Control. This is handy for Cranking the Crackle knob so you

can squeeze out all of the tone without the added volume!

Note: v2 wiring diagram last page.

Board Dimensions (W x H): 1.10” x 1.10”

Part

Value

Part

Value

33k

100n

10u

10M

47u

10M

Bi-Color LED C.A.

100K

5k1

P1-Crackle

C5k

3k3

P2-Volume

A100k

1N4148

BS170

1N4148

SW1

3PDT

Summary of Contents for SHO' Nuff

Page 1: ...handy for Cranking the Crackle knob so you can squeeze out all of the tone without the added volume Note v2 wiring diagram last page Board Dimensions W x H 1 10 x 1 10 Part Value Part Value R1 33k C1 100n R2 1M C2 10u R3 10M C3 47u R4 10M D3 Bi Color LED C A R5 100K R6 5k1 P1 Crackle C5k R7 3k3 P2 Volume A100k D1 1N4148 Q1 BS170 D2 1N4148 SW1 3PDT ...

Page 2: ... Volume Pot P2 simply Jumper pads 2 3 together on the main board STATUS LED Note If wiring the LED to our 3PDT board no need to connect S4 S5 S6 or populate D3 or R7 CLR on the main board since you are wiring your LED directly to our board ...

Page 3: ... for battery use only has a RING lug which is used to connect to the battery ground If you do not intend to use a battery there is no need for a Stereo Jack If using Stereo then only use the Tip and Sleeve lugs S4 S5 S6 is only needed when the LED is wired to the Main Board ...