background image

06/07/17

3652

1

3

1

1

1

1

1

2

CS 30056 - 45 RUE GASTON DE FLOTTE

13012 MARSEILLE CEDEX 12 (FRANCE)

TEL : 33.(0).4.91.87.51.20 - FAX : 33.(0).4.91.93.86.89

www.gymnova.com - info@gymnova.com

Constantly aiming to improve our products, we reserve the right to make changes to the equipment and dimensions without further discussion.

Warning

This equipment should be installed by a qualified individual.
This equipment should only be used by one person at a time, under the supervision of a qualified individual.
Using this equipment for purposes other than those originally intended is prohibited.

Recommendations

As set out in French Standard NF S52-400 the following is recommended:

-

keep these instructions for subsequent reference (inspection, maintenance, etc.).

-

periodically carry out predictive maintenance.

-

depending on how much it is used have the equipment serviced yearly or every few years.

Pack list

1 Pack (Ref: 3652)

Dimensions: 610 x 410 x 240 mm

Weight: 6 kg

Volume: 0.06 m

3

I. Assembly of the cover

A

SSEMBLY

I

NSTRUCTIONS

R

EMOVABLE

B

EAM

  C

OVER

M’16

KEEP THIS

DOCUMENT

Wipe over the existing body with a dry cloth to remove any unwanted particles (fragments of magnesium, etc.).

Fit the new cover 

(1)

 over the existing body: start with one end then fit the other end.

FRAGILE

Use the end caps 

(4)

 provided if necessary (end caps damaged or non-existent) for Gymnova beam bodies. Refer to

instructions NM135.

NM272B-GB

Summary of Contents for 3652

Page 1: ...ions As set out in French Standard NF S52 400 the following is recommended keeptheseinstructionsforsubsequentreference inspection maintenance etc periodically carry out predictive maintenance depending on how much it is used have the equipment serviced yearly or every few years Pack list 1 Pack Ref 3652 Dimensions 610 x 410 x 240 mm Weight 6 kg Volume 0 06 m3 I Assembly of the cover ASSEMBLY INSTR...

Page 2: ...e side through each slot in the removable cover 1 NM272B Page 2 Check that the cover 1 is properly centred on the body lengthwise same fabric fit at both ends and equally balanced on both sides The rods are slightly longer than the cover therefore you need to insert one end into a pocket step 6 then push the rod as far as it will go in the direction shown in step 6 in order to insert the other end...

Page 3: ...ny damaged or distorted component should be replaced as quickly as possible NM272B Page 3 Start at one end of the beam and repeat the operation on each self gripping strip 3 Pull each strip with moderate force to tighten the cover 1 Once all the self gripping strips are attached adjust by tightening them further if necessary Each time you tighten a self gripping strip check that the cover is still...

Page 4: ...IAL AND SHALL NOT BE REPRODUCED WITHOUT OUR PRIORAUTHORIZATION R EMOVABLE B EAM C OVER M 16 Service kit each Set of 14 self grip strips Complete plastic end cap Self gripping strip Pair of rods Ø6 Length 5025 Removable Cover M 16 3652 22 3610 77 3652 12 3652 03 REFERENCE REMARKS ITEM QTY DESCRIPTION 2 2 2 8 1 1 BY M CHARBONNEAU DATE 06 07 17 NM272B GB Ref 3652 ...

Reviews: