1
H3C WX3500H Series Access Controllers Installation Quick Start-6W104
H3C WX3500H
系列无线控制器 快速安装指南
-6W104
BOM:3104A0FG
Tool list
工具参考
Introduction to installation accessories
安装附件介绍
2
Cage nut
(user-supplied)
浮动螺母（用户自备）
Grounding cable
(provided)
地线（标配）
Removable cable tie
(user-supplied)
可拆卸式扎带（用户自备）
M6 screw
(user-supplied)
M6
螺钉（用户自备）
Mounting bracket
(provided)
挂耳（标配）
Rubber feet
(provided)
脚垫贴（标配）
Console cable
(provided)
配置电缆（标配）
The installation tools are not provided with the access controller. Prepare them yourself.
设备不随机提供安装工具，请用户根据实际安装需求自己准备安装工具。
Needle-nose pliers
尖嘴钳
Wire-stripping pliers
剥线钳
Diagonal pliers
斜口钳
Marker
记号笔
Phillips screwdriver
十字螺丝刀
The WX3500H Series Access Controllers include the WX3510H, WX3520H and WX3540H models.
The installation procedures are the same for the three models. This guide uses the WX3540H
access controller as an example.
WX3500H
系列包括
WX3510H
、
WX3520H
和
WX3540H
三款无线控制器，安装方式完全相同，本文
以
WX3540H
为例介绍设备的安装过程。
Flathead screwdriver
一字螺丝刀
ESD wrist strap
防静电腕带
Heat gun
热风枪
Wear an ESD wrist strap, and make sure the wrist strap makes good skin contact and is reliably
grounded.
操作者需佩戴防静电腕带，确保防静电腕带与皮肤良好接触，并确认防静电腕带已经良好接地。
!
Mounting the access controller on a workbench
安装设备
到工作台
Make sure the air inlet and outlet vents are not blocked and the installation site has a good ventilation system.
请确保设备的进、出风孔不被遮挡，并将设备安装在具有良好通风散热系统的环境中。
Airflow of the access controller
设备的风向设计
Make sure the workbench is stable and reliably grounded.
Do not place heavy objects on the access controller. Attach
the rubber feet to the four round holes in the chassis bottom.
Place the access controller on the workbench.
保证工作台的平稳与良好接地，并且不要在设备上放置重物。
粘贴脚垫贴到设备底部，将带脚垫贴的设备平放到工作台上。
Left-to-right airflow.
设备采用左进右出的风道设计。
Summary of Contents for WX3500H series
Page 4: ......
