Haas MDC-500 Installation Manual Download

Page: 1 / 8

LAST UPDATED: 11/30/2018

MDC-500

- Rotary Unit Installation

Prerequisites

Make sure that the MDC-500 has the additional axis drives installed to support the additional axis. If a second mocon

PCB is required, make sure it is installed before installing the additional axis.

Electrical Safety



Caution:

When you do maintenance or repair on CNC machines and their components, you must always follow

basic safety precautions. This decreases the risk of injury and mechanical damage.

• Set the main circuit breaker to the

[OFF]

position.



Danger:

Before beginning any work inside the control cabinet the High Voltage indicator light on the 320V Power

Supply / Vector Drive must have been off for at least 5 minutes.

Some service procedures can be dangerous or life-threatening. DO NOT attempt a procedure that you do not fully

understand. If you have any doubts about doing a procedure contact your Haas Factory Outlet (HFO) and schedule a

service visit.

MDC-500 Rotary Unit Installation

Page 1 of 8 pages

Summary of Contents for MDC-500

Page 2: ...MDC 500 Rotary Unit Installation MDC 500 Rotary Unit Installation Page 2 of 8 pages ...

Page 5: ...10 Disconnect the pallet changer amplifier cable from its socket on the first Mocon PCB and connect it to the Z Axis socket on the second Mocon PCB MDC 500 Rotary Unit Installation Page 5 of 8 pages ...

Page 6: ...MDC 500 Rotary Unit Setup and Configuration MDC 500 Rotary Unit Installation Page 6 of 8 pages ...

Page 8: ...sufficiently clear the machine walls 5 Align the pallet as close to the home position as possible Reset the EMERGENCY STOP button 6 Press ZERO RETURN Type in the letter of the axis of the pallet Press SINGLE to align and reclamp the pallet MDC 500 Rotary Unit Installation Page 8 of 8 pages ...