Cutting Pliers if using a metal chain
Cut down the axle rod and ensure it is
10.8cm shorter than the overall with of
Take each spool and ensuring each grey
button is up, insert them into the headrail.
Attach the axle rod into the Dual Rise gear
housing and tighten firmly using a T10
Insert the axle rod through each of the spools
inside the headrail.
Slightly undo the small screws on the top of the
Dual Rise gear housing taking care to ensure
it doesn’t come out and push it inside the headrail.
once in about three quarters of the way turn the
headrail over and lift up the small flap so it goes over
the top of the headrail.
Push the final section of the Dual Rise gear
housing firmly in, ensuring it sits flush with
