GBMAKV*B GBMAHV*B
97744C (8/01)
PAGE 1
HALSEY TAYLOR OWNERS MANUAL
USES HFC-134A REFRIGERANT
FIG. 1
INSTALLATION
1. Locate water cooler in a well ventilated space where temperature is always
above freezing.
2. Insure proper ventilation by maintaining a minimum clearance of 2(51mm)
on sides and rear of cooler.
3. Make sure cooler is on a level surface.
START UP
1. Install drip tray below faucet.
2. Thoroughly clean the cooling tank and baffle. Baffle must be in place for
proper cooling operation.
3. Remove the cap from bottle and invert the bottle on the top of the unit.
CAUTION: Avoid filling the water tank above the level normally maintained
by inverted bottle.
4. Hold faucet handle down until air bubbles rise in water bottle. On hot
models, depress hot faucet handle until water flow is continuous and clear.
Connect cooler to electrical supply.
CAUTION: HOT TANK MUST BE FILLED WITH WATER BEFORE
CONNECTING TO ELECTRICAL SOURCE.
CLEANING
ALL PLASTIC PARTS ARE DISHWASHER SAFE.
Bottle ring, drip tray and shelf can be cleaned with any NON-abrasive house-
hold cleaner. To prevent damage to plastic parts, avoid abrasive cleaning aids
such as steel wool, etc.
MAINTENANCE
TEMPERATURE CONTROL (Cold Control): The thermostat is set to deliver
water at approximately 45° F. (7° C.). For colder water, adjust the screw on the
thermostat clockwise. The thermostat is located at the rear of cooler.
TEMPERATURE CONTROL (Hot Water): The thermostat is factory set to
deliver water at approximately 180° F. (82° C.) and is not adjustable.
CAUTION: HEATER TANK MUST BE FILLED WITH WATER BEFORE CON-
NECTING TO THE ELECTRICAL SOURCE.
LUBRICATION: None required.
CONDENSER: To ensure optimum cooler performance, condenser must be
maintained free of dust and lint. Condenser must be regularly inspected and
cleaned with a brush.
DRIP TRAY: The drip tray should be emptied and cleaned regularly. To remove
pull drip tray straight forward from the cabinet.
REPLACING WATER BOTTLE: Depress faucet handle(s) until air bubbles rise
in bottle after each replacement, this will ensure correct water level for proper
operation.
STORAGE or RETURN SHIPMENT: If the cooler is removed from service, the
water must be completely drained from the system.
