1
Use and Care Guide
LOW VOLTAGE LED FLOOD LIGHT
PACKAGE CONTENTS
B – Wire Connector x1
A – Lamp Body x1 (with 12 in. wire attached to lamp body) C–Ground Stake (6.535 in.) x1
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING:
Never push the fixture into the ground by the lamp
body (A) or use a hammer to insert the ground stake (C) into the
ground.
□
Insert the fixture wire on the wire connector (B) into the groove
located on the top of the ground stake (C).
□
Screw the lamp body (A) onto the top of the ground stake (C). Ensure
the fixture wire on the wire connector (B) stays in the center of the
groove of the ground stake (C) to avoid damage to the fixture wire.
□
Prepare a hole in the installation location. Use a tool such as a
screwdriver (not included) to prepare the installation hole to ensure
the hole is not larger than the ground stake (C).
□
Install the ground stake (C) in the ground by pushing on the lamp body
(A).
□
The lamp body (A) can rotate up and down 130 degrees.
WARNING:
The wire connector (B) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□
Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□
The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (B) on opposite sides of the low voltage
cable (not included) from the transformer (not included) where
the fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of
the wire connector (B).
□
Press the wire connector (B) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
□
Once the wire connector (B) is in place, it is recommended to
wrap it with electrical tape (not included).
□
After all fixtures are installed, turn on the transformer.
Item # 1008 242 986
Model #
KIF2301LS-01
