OPERATING and MAINTENANCE
RECOMMENDATIONS
for MODEL TS 400
READ THOROUGHLY AND UNDERSTAND THIS PUBLICATION BEFORE ATTEMPTING
TO OPERATE THE EQUIPMENT.
P.O. Box 393
Wadsworth, OH 44282, U.S.A.
Tel: +1 330 336 4550
Fax: +1 330 336 9159
www.hstool.com
Recommended Setup Procedure
Guide Rail
Blade Arbor
Wrench Weld Tab
Wrench
Membrane
Slitting Bracket
Carriage
Lock
Membrane Removal Blade,
Outside Membane Arbor and Bolt
Panel
Blade
Saw Power Unit
with Carriage
Weld Tabs with
Line Indicators
Weld Tab Screws
1. Remove guide rails from the shipping tube.
Loosen the weld tab screws with the wrench
provided and swing them to a position that is 90
o
to the guide rail. Tighten the tab screws.
3. Weld the tabs in
position and check for
cut line accuracy. Do not
remove the line indicator
unless it needs
replacing. Additional
guide rail sections can
be added for longer cuts.
Slide the male connector into
the next guide rail section and
bolt them together with the cap
screw provided. Weld additional tabs into place.
2. Establish your cut line
and set the weld tab
assembly against the
panel. The top of the line
indicator must be on the
cut line. If the weld tabs
are not at a place where
they can be welded,
remove the tab bolts and
relocate the tab to a suitable locator hole.
4. Mount the saw power
unit/carriage assembly
onto the guide rail.
Align the guide shoes
with the top and bottom
of the guide rails. It
should slide easily
without being so loose that it will affect the
cutting accuracy.
DANGER!
The application of this product requires an exposed rotating cutting blade. It
produces HOT, SPARKS requiring that eye, ear, and hand protection and other
appropriate protective clothing be worn at all times. Do not wear loose fitting clothing
that may become entangled with the rotating objects.
Bracket
Lock
Guide Rail
Connector
Outside Panel
Arbor and
Bolt
