HD Rehab AB
, Tryffelslingan 4, 181 57 Lidingö, Sweden
tel. +46(0)8-767 04 80 info@hdrehab.se www.hdrehab.se
MD
Intended use
Tray table is intended as a general resting surface during daily activities, such as when eating.
Parts included
Assembly
Remove the screw and pull out the plastic plug from the armrest rail at the back of each armrest.
Slide the mounting pin along the slot in armrest rail. Place the mounting pins at approximately the
same depth on both sides. Put the plastic plugs and screws back in place in the armrest rails.
Check if the armrests are set in the inner, middle, or outer position on the wheelchair. Screw the
fittings in place on each side of the tray table in the corresponding position.
Tray table
Art. nr. 39541-5 / 39551-5
Doc. nr. 96805-1 Rev A 2020-10-02
Inner position
Middle position
Outer position
User manual /
Assembly instructions
Page 1 (2)
1 x fitting LH
4 x screw
MC6S M5x10
1 x fitting RH
2 x
mounting pin
1 x tray table
1
2
3
3
2
1
