RC04B Instruction
IMPORTANT
This manual includes essential information on the safety measures to be implemented
for installation and start-up. Therefore, the installer, as well as the user, must read
these instructions before beginning installation and start-up. To achieve optimum
performance, follow the instructions indicated below
SPECIFICATIONS
Water-resistant level: IP65
Dimension: 195mm x 195mmx 90mm
Weight: 3.8Kg
Input Voltage: 220~240V AC
Output Voltage:
12V AC
Working temperature: - 4 0 ºC ~ + 7 0 ºC
Working humidity: 1 0 % ~ 9 0 % R H
Range: Within 100 meters
PACKING
RC04B Controller × 1 Remote emitter × 2
GENERAL CHARACTERISTICS AND INFORMATION
RC04B is a controller used to operate the LED underwater lights using a remote
control. The control range can be up to 100 meters according to the actual environment.
There is a single-phase 220W step-down transformer that is used to lower voltage from
220V to 12V. This transformer is designed primarily for underwater pool and fountain
lights. This transformer can be fixed for both new and old pools. There is a safety fuse
inside. It is recommended
not
to install this unit more than 15 meters away from the
pool. The manufacturer is not responsible in any circumstances for assembly,
installation or start-up of any electric components that have been inserted or handled
at locations other than its own premises
INSTALLATION
Prior to commencing, make sure there is no electricity passing through the wires and
cables to be connected. Mount the transformer on a solid and secure wall at a
minimum distance of 2 meters from any water source or pipes. Connect the 220V input
voltage into the terminals clearly marked as
220V AC INPUT
.
Connect the lamp cables
to the terminals clearly marked as
LAMP 12VAC OUTPUT
. It is good practice to check
and verify that there is a fuse inside the fuse carrier, and that it is functioning. It is
essential to make sure the connections are as tight as possible in order to avoid
