HIMAX
Electric Screwdriver
TL Series
DC 20/30V
Operating instructions
Note
This electric screwdriver is designed for indoor use only.
Please do not use it in outdoors or wet environment to prevent
the danger of electrocution.
Pay attention to the voltage specification. Make sure the switch
is in the OFF position when you plug in the power.
Unless you are a trained maintenance personnel, do not
disassemble the device lest it cause dangers or more damages.
Please use the original power transformers for the TL model
lest it generates dangers or imprecise torque due to wrong
output specification.
Operating instructions
●
Make sure the power is switched off to install or replace
screwdriver bits; press the front-end iron cap will allow the
screwdriver bits to be inserted or released.
●
It is recommended to suspend the electric screwdriver by a
flexible balancer for easy operation and prevent its dropping.
●
Adjust the torque dial to the proper position according to the
dial/torque table for each model.
●
The forward/reverse switch should be set to the forward
position when fastening screws. Press the start switch to
complete the operation. The automatic control model will shut
off the power and stop the rotation of the screwdriver bit as
soon as the set torque value is reached.
●
Position the forward/reverse switch to reverse to loosen screws.
●
Use hands to hold the electric screwdriver during operation.
Keep it in a perpendicular position with the screw and apply
pressure slightly to prevent slipping.
●
Use hands or other means to fix the object operated and operate
the electrical power screwdriver safely.
●
Do not press the start key abruptly again after the completion
of the fastening operation each time.
●
Do not switch the forward/reverse position and improper
switch operations when the motor is running to prevent the
short-circuit of the start switch.
●
Use it under the normal operation frequency ( 8 working hours
per day and fasten 800-1000 screws per hour) without
exceeding the operation load will extend the life time of the
electric screwdriver and reduce the occurrences of malfunction.
●
Please do not use this type of electric screwdriver to fasten
wooden screws.
Regular simple maintenance
Check to see whether all the parts, shell, and power lines are intact
all the time to ensure normal operations. Unplug the power plug and
turn off the power before doing any maintenance operation to ensure
safety. For every 1000 hours operation or half year, the following
cleaning and maintenance operations to the machine body and the
inside are required:
Replacement of Carbon brush
When carbon brush wears to 1/2 of the original length, it needs to be
replaced and the accumulated carbon powder removed to prevent
the short-circuit of the circuitries.
Lubrication of machine parts
The gear transmission machine parts should be greased with special
gear grease to keep the operations smooth and reduce wear.
Power Supply
CLT-50
CLT-50s
TL low voltage direct current model requires the matching
CLT-50 / CLT-50S power supply.
Use the accessories, 5P dual power line to connect the electric
screwdriver and the power supply.
Make sure the right voltage to be used before the connection of
power. Turn the switch to Ho/Lo position and the LED
red-light will lights up to indicate that the power is on and
ready to use.
The output voltage: HI/30V, LO/20V if switched, the speed of
the electric screwdriver will be changed accordingly. Please use
the attached clip to fix the CLT-50S to prevent drop and
damages.
Bits Shanks
