User Manual
Before Using Your WiTouch
Device
Sync the Remote Control and the
WiTouch Device
1. Using the provided screwdriver, remove
the back cover from the WiTouch device.
2. Remove the clear plastic tab from the
remote control.
3. On the remote control, press and hold
the (+) and (-) buttons simultaneously
until the LED appears solid green
(~ 10 seconds).
4. Quickly insert the batteries into the
WiTouch device.
Note:
The LED on the remote control will
flash several times indicating syncing is
complete.
5. Replace the back cover on the device.
Note:
You may need to re-sync your
remote control and WiTouch device when
you replace the battery in the remote
control. This will ensure communication
between your remote control and WiTouch
device. If your remote control and WiTouch
device ever lose communication, please
repeat these syncing instructions.
Hollywog
2830 Amnicola Hwy
Chattanooga, TN 37406 USA
423 305 7778
info@hollywog.com
www.hollywog.com/witouch
TM and © 2014 Hollwog, LLC. All rights reserved
Patents Pending
11S.1003F
2
3
4
5
1
