ADEMCO 5802WXT-2 Supervised Miniature
Transmitter – Installation Instructions
General Information
The ADEMCO 5802WXT-2 is a wireless transmitter that may be worn around
the neck, on a wrist band or as an apparel clip that may also may be mounted
to a desk, dresser, etc. (necklace, band, and clip supplied). Pressing both
buttons on the transmitter at the same time sends a signal to the control
receiver. The 5802WXT-2 is intended for use only with wireless alarm
systems that support 5800 Series devices.
The transmitter is supervised, i.e., it automatically sends a message to the
control receiver that includes battery status information every 70-90 minutes.
This transmitter can be programmed as any zone type response (e.g.,
Emergency Panics, Relay Action, etc.).
Programming the Serial Number
The 5802WXT-2 has a unique identification code (serial number)
permanently assigned during manufacture.
You must “enroll” the transmitter’s serial number and loop number during
system programming. The 5802WXT-2 may be defined as Input Type “RF”
(supervised RF, for an hourly check-in;
do not
take out of range) or “UR”
(Unsupervised RF). Its loop number is “1.” See the control unit’s Installation
Instructions for further details regarding programming. When installation is
complete, verify operation from desired location(s).
Operation
5802WXT
-2-001-V0
