K3636V3 9/04 Rev. B
ADEMCO 5804BDV
TWO-WAY WIRELESS KEY with VOICE STATUS
USER GUIDE
About the 5804BDV
The 5804BDV is a four-button remote control for your alarm system. It can send a command to the alarm system, such as to arm or disarm, as well as
receive system status. Two LEDs and a speaker indicate system status. The 5804BDV is typically used for arming, disarming, and home automation.
Check with your installer to understand which functions the buttons have been assigned on your unit.
Operating the Buttons
Activating a Function
To activate a function, press and hold the appropriate button down until the yellow LED flashes, and then release it.
Requesting System Status
You can check system status before arming or disarming your system.
Check your system status by momentarily pressing and releasing any button. The yellow LED will flash after you release the button. After a second or
two, the 5804BDV will display the system status through the LEDs and speaker (see the System Status Indications Table, below). If the 5804BDV does
not receive system status from the panel for approximately 5 seconds, it will shut itself down. It will also shut itself down if you do not press a button
within 5 seconds of receiving a status update.
System Status Indications Table
LED
LED Condition
Speech
System Status
System Armed Away
Armed Away or Maximum
On Steady
System Armed Stay
Armed Stay or Instant
Fire Fire Zone (Faulted Zone)
Fire Alarm in progress
Alarm Alarm Zone (Faulted Zone)
Armed, Burglary Alarm in progress
Red
Flashing
Alarm Alarm Zone (Faulted Zone)
Alarm Memory
On Steady
System Disarmed Ready To Arm
Disarmed, Ready to Arm
Green
Flashing
System Disarmed Not Ready To Arm
System Not Ready, Zones Faulted
Yellow (right)
Flashing
—
Indicates RF transmission
In Enter House ID Mode
Red & Green
Alternately
Flashing
—
In Set Volume Level Mode
System AC Loss
AC Loss Condition
NA NA
Low Battery
Low Battery Condition
Multiple Button Operations
!
WARNING!
The 5804BDV should not be used for silent
panic operation.
The 5804BDV can generate the same responses as keypad panic key pairs
of [*] + [#] and [*] + [1] by depressing “A” + “C” and “B” + “D” button pairs,
respectively. You must depress the button pair for at least 2 seconds for the
5804BDV to recognize the button pair command. These button pairs allow
you to activate panic, fire, and medical alarms depending on control panel
programming.
5804BDV-005-V0
A + C Button Pair
B + D Button Pair
Adjusting the Volume Level
To enter the Volume Level mode, press and hold down the A, B, and D buttons at the same time until the unit’s red and green LEDs flash alternately. If
no button is pressed within 5 seconds, the unit will automatically shut down and no change to the volume level is made. Press the A button for low
volume level, the B button for mid volume level, and the C button for maximum volume level. You will hear the word “Alarm” at the selected volume. Then
press the D button to accept the selected sound level. Note that volume level affects the life of the battery. Use low volume for maximum battery life.
Low Battery Indication
When the unit goes into a Low Battery condition, the yellow LED will not flash when a button is pressed. Change both batteries immediately.
