GSMX-AUDIO and GSMV-AUDIO, Audio Cable Routing Instructions
For Online Support visit: http://www.security.honeywell.com/hsc/resources/MyWebTech/
Routing Instructions for the GSMX-AUDIO cable.
1.
At the GSMX, loosen the captive cover screw and swing the
cover open. Open the enclosure where the AVS Base Unit
resides.
2.
Ensure power is removed by disconnecting the GSMX’s ECP
cable, and powering down the control and AVS Base Unit.
3.
Connect the
5-pin end
of the audio cable to the audio
connector on the GSMX circuit board.
4.
Route the audio cable to the connector on the AVS Base
Unit.
5.
Connect the
4-pin end
of the audio cable to the
connector on the AVS Base Unit.
6.
Ensure the audio cable ends are secured with tie
wraps to reduce strain.
7.
At the GSMX, connect the ECP cable. Close the cover
and tighten the captive screw.
8.
At the AVS Base Unit, close the enclosure.
9.
Power up the system, and test.
A
UDCBL-001-V0
AVS BASE UNIT
2
3
4
1
ON
5
2
3
4
1
ON
AUDIO
CONNECTOR
5-pin connector
4-pin connector
