background image

 

WAP Wireless Access Point – Quick Installation Guide 

For Online Support visit: http://www.security.honeywell.com/hsc/resources/MyWebTech/  

 
 

General Information 

This guide provides information on installing and setting up Honeywell's WAP Wireless Access 
Point.  The WAP provides an easy-to-setup secure wireless solution that enables Honeywell's 
iPCAM series internet video cameras to communicate with a broadband modem or LAN. 

Some major features of Honeywell's WAP Wireless Access Point are: 

  Functions as a secure wireless access point.  

  Wireless communications utilizes the 802.11b/g/n protocol with WPS security.  WPS (Wi-Fi 

Protected Setup) is a standard for easy setup of a secure wireless network. 

  In addition to wireless communications, there are three 10/100 Mbps Ethernet ports 

available for wired cameras.  

IMPORTANT: This device is for indoor use only.  

 

PACKAGE CONTENTS 

LAN

Wir

eless

WPS

Reset

Secur

ity

Powe

r

 

WAP Wireless Access Point

 

 

 

Antenna [Qty 2] 

 

Power Transformer

 

 

Ethernet Cable

 

Component Identification

 

 

Security   WPS      Wireless    LAN    Power                                        Reset

 

 

Security: 

  

On – WPS security is set to on. 
Flashing – Flashes when WPS button has 
been pressed for 3 seconds and released, 
to indicate the WAP is transmitting a new 
security key to the wireless camera.  When 
the wireless camera replies, the Security 
LED lights solid.  

WPS (button): 

Used to setup a secured 

wireless connection.  (Refer to the 
documentation for the wireless camera.) 

Wireless:

  

On – Wireless connection exist. 
Off – No Wireless connections exist. 
Flashing (Amber) – Problem occurred while 
trying to establish the Wireless connection. 
 

LAN:  

On – The LAN port(s) is active. 
Flashing (Amber) – Problem occurred while 
trying to connect to the LAN.

 

Power:

 When power is applied the LED 

blinks during an initialization period, then 
remains steady to indicate power is 
connected.

 

Reset (switch):

 This switch has two 

functions; Reboot, and Clear All Data.  Use 
a paper clip to depress. 
Reboot – Depress and Release to reboot.  
(Allow cycle to complete.) 
Clear All Data – Depress and hold for 8 
seconds to clear all data, and restore 
factory settings.  (Allow cycle to complete.) 

 

 

 

 

12V / 1A:

 Connect Power Transformer. 

WAN: 

Not Used. (Do not remove the cap plug.)

 

Ports 1, 2, 3, 4: 

For connection to Ethernet devices.

 

Antenna Ports: 

Connect the supplied antennas to these ports. 

 

 

 

 

 
 
 
 
 

Antenna 
Port (2)

 

Reviews: