WHR-HP-G300N Router Settings (For: Pccw, HGC PPPoE User)
Last Updated 28/11/2009 Hornington KB: http://kb.hornington.com WHR-HP-G300N PPPoE Settings Page 1
4.
Please connect your broadband service with a network cable (or from
Hardware Setup of WHR-HP-G300N Router:
cable modem) to the “
INTERNET
” port on the ROUTER. Then use
another network cable to connect “
LAN1
” port on the ROUTER to the
1. Set
Router
switch to “
ON
”.
Ethernet adapter on your PC. Make sure indicators “
INTERNET
” and
“
LAN1
” near lan ports are
ON
.
2.
Power on Buffalo Router, and wait for 2 minutes.
The “
Power
”, “
Wireless
” and “
Router
” indicators will be
ON
, and
“
DIAG
” will be
OFF
.
3.
To reset the router, please insert “RESET” hole by a paper clip for about
10 seconds, and wait for 2 minutes. The “
Power
”, “
Wireless
” and
“
Router
” indicators will be
ON
, and “
DIAG
” will be
OFF
.
5.
For i-cable user, please power off modem for 1 hour
. Then power on
modem
again.
.
Wait for 2 minutes.
