Light Duty Tiller
A lightweight tiller designed for use
in small areas previously turned.
Never push the equipment beyond its design limits.
If
it will not do what you want with reasonable ease and
speed, assume you have the wrong tool for the job.
Contact your local HSS Hire for advice.
Keep the equipment clean
– you will find this less of a
chore if you clean it regularly, rather than wait until the end
of the hire period.
Regularly check the fuel level and top up as necessary
with unleaded petrol.
EQUIPMENT CARE
Regularly check the oil level
– when the engine is cold
and on level ground. Unscrew the dipstick, wipe it clean,
then replace it into the opening without screwing it back in
place. Remove it a second time and verify that the oil level
is between the min and max lines,
top up as necessary.
When not in use,
store the equipment somewhere clean,
dry and safe
from thieves.
Release the throttle lever to set the engine to idle, close
the fuel tap and set the ON / OFF switch to the ‘0’ (OFF)
position. Close the breather valve by turning fully
clockwise.
Reset the depth bar as high as it will go.
Hose the machine down to get it as clean as possible
(do this now before the soil dries)
ready for return,
to your
local HSS Hire.
FINISHING OFF
Code 62506
Fuel
Cap
Breather
Valve
Fuel
Tank
Pull
Start
Pull
Start
Engine
Oil
Fuel
Tap
Choke
Lever
Engine
Light Duty Tiller
Operating & Safety Guide 999
Operating & Safety Guide 999
999/02
999/02
©HSS Hire Service Group Ltd 2007 No. 999/02
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
…any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments
or write to the Safety Guide Manager at the address below
e-mail: safety@hss.com
...... h
ha
av
ve
e y
yo
ou
u b
be
ee
en
n ttrra
aiin
ne
ed
d
The law requires that personnel using work equipment
have received adequate training and must be competent
when using the equipment within the workplace.
Training is available at HSS Training Solutions
0845 766 7799
