www.HunterFan.com
1.888.830.1326
Model 99119
Universal 3 Speed
Ceiling Fan Remote
Installation
Wiring
OR
OR
OR
Remove the canopy. If uncertain
how to remove it, reference the fan’s
owner’s manual. With wiring exposed,
it may be helpful to note existing wire
connections or take a digital photo for
reference. Remove the wire connectors
that connect the wires from the outlet
box to the fan, leaving the grounding
wires connected.
CONNECT WIRES FROM RECEIVER TO FAN -
Using the orange wire connectors, connect the blue wire from the
receiver to the blue wire (or possibly black with white stripe wire) from the fan. Connect the yellow wire from the
receiver to the black wire from the fan.
If you’re uncertain about wire colors or connections, please contact a qualified electrician.
CONNECT WIRES FROM RECEIVER AND FAN TO WIRES FROM OUTLET BOX
- Using the orange wire connectors,
connect the black wire (ungrounded) from the ceiling to the black wire from the receiver. Connect the white wire
(grounded) from the ceiling to both the white wire from the receiver and the white wire from the fan.
AFTER ALL WIRES ARE CONNECTED
and secured with wire connectors, re-install the canopy.
Choose the hanging system that most closely resembles the one used by your fan and install the receiver as shown and wire as directed.
Note:
Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8” remaining. Re-strip the fan lead wires 1/2”. Place remaining excess
wire into the ceiling electrical box.
The bracket and fan must remain properly grounded.
You may have installation issues if the fan is installed on an angled ceiling. For assistance, call 1-888-830-1326.
Ceiling
Plate
Receiver
Canopy
Receiver
Canopy
Ceiling
Bracket
Receiver
Fan Body
Cable Tie
For low profile fans, the receiver should
be secured to the ceiling bracket with a
cable tie.
Receiver
Canopy
Turn the splices upward and push them carefully back through the hanger bracket
into the outlet box. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the outlet box.
To avoid possible electrical shock, before installing or servicing your fan, disconnect
the power by turning off the circuit breakers to the outlet box and associated wall
switch location. If you cannot lock the circuit breakers in the off position, securely
fasten a prominent warning device, such as a tag, to the service panel.
FRO
M CEILING
FR
OM RECEIVER
black
blue
yellow
blue
FROM FAN
M0058-01 • 01/14/14 • © Hunter Fan Company
Turn
Pow
er
OFF
Before installing the
Universal Remote Control
Receiver, use the pull chains
to set the fan speed to HIGH
and the light to ON. Be
sure power is OFF before
proceeding with installation.
If you are installing multiple remote-controlled fans
on the same circuit breaker
,
you may need to perform a few extra steps to prevent
interference or faulty operation of your remote controls.
Go to www.HunterFan.com/FAQs and click “How do I properly
install multiple remote-controlled fans?” for more information.
FR
OM R
ECEIVER
black
white
white (grounded)
black (ungrounded)
white
FROM FAN
