WARNING:
Designed for use in Diesel Exhaust Fluid (DEF)
dispensers only.
NOTE: Always adhere to installation / usage instructions and warning. Improper use may result in injury, damage or
hazardous spill.
1. Turn off dispenser and relieve line pressure.
2. Apply DEF compatable thread sealant to NPT threads of mating fitting.
3. Only connect to DEF compatible and 304 stainless steel fittings - see page 2 for
applicable seal configurations.
4. Install at the nozzle or other appropriate location for 1" BSPP Male x 1" NPT Female
fittings.
5. Tighten firmly, approximately 15 - 20 lbf•ft / 20.3 - 27 N•m, but do not overtighten.
6. Pressurize system and visually check for leaks.
VERIFY SMOOTH ROTATION OF ALL SWIVEL JOINTS AFTER INSTALLATION.
DO NOT OVERTIGHTEN
Husky Corporation • 2325 Husky Way • Pacific, MO 63069 • Phone: (800) 325-3558 • Fax: (636) 825-7300 • www.husky.com
Page 1 009338-5 9/2018
MADE IN THE USA
INSTALLATION INSTRUCTIONS
IF DRIVE OFF OCCURS
Daily
• Check for leaks / stains
• Check for damage
• Check for smooth rotation of all
swivel joints.
Monthly
• Measure gap at joint - a credit
card should not fit in the gap
(0.03 in / 0.76 mm).
• Check "remove after" date.
Annually
• Check for electrical conductivity
• Only clean / rinse exterior surfaces
of DEF product with deionized water.
• All drive aways, maintenance and
inspection activities must be logged
using the serial number of the
individual product.
• Apply city, state, or federal testing
regulations as appropriate.
ANY TEST / INSPECTION
FAILURE REQUIRES IMMEDIATE
EQUIPMENT REPLACEMENT OR
REMOVAL FROM SERVICE.
Diesel Exhaust Fluid (DEF) Swivels
Model 008510
Recommended Installation, Maintenance
and Inspection Instructions
008510 DEF SWIVEL
TESTING / MAINTENANCE / INSPECTION
• Turn off dispenser and relieve line pressure.
• Inspect the entire dispensing system for damage.
• Pressurize system and visually check for leaks.
• Check for smooth rotation of all swivel joints.
• Measure gap at joint - if a credit card fits in the gap (0.03 in / 0.76 mm) do not reinstall.
• Check for electrical conductivity.
I
mportant
safety
InstructIon
-
save
these
InstructIons
In
a
readIly
accessIble
locatIon
.
