Part No.: INST-HHD2500 02/12
Installation and Maintenance Instructions
THESE INSTRUCTIONS MUST BE READ FULLY BEFORE
COMMENCING INSTALLATION
Code
Supply
Watts
Amps
HHD2500RB
HHD2500RW
230-240V/1Ph/50Hz
230-240V/1Ph/50Hz
2400
2400
10
10
1.0
GENERAL
1.1
It is important these Installation and Maintenance Instructions are fully adhered to.
1.2
Full details of the unit supplied are shown on the product nameplate. If in doubt about any detail
contact HYDOR or its agents for clarification.
1.3
All electrical installation must be carried out by suitably qualified and competent
personnel in accordance with all current statuary requirements.
1.4 Any declarations made by HYDOR about product installation and safety, are
dependant on the hand dryer being used within installations which themselves
meet the requirements of the relevant Standards and Directives of your region.
1.5 The hand dryer must be installed indoors in a dry, sheltered position and is designed for use in
an ambient temperature of up to 40
°
C. The hand dryer is not suitable for corrosive or explosive
atmospheres.
1.6
The installer should provide easy access to the hand dryer to facilitate future maintenance.
1.7
The installer should ensure the hand dryer is adequately supported.
1.8
This product is not intended for use by persons (including children) with reduced sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the product by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the product.
