The information contained herein is intended for the use of the individual(s) named above and those authorized to receive it. Dissemination, distribution
or copy of this information is strictly prohibited.
ASSEMBLY INSTRUCTIONS PLEASE READ CAREFULLY
Model No.
Inside
Dimensions
Outside
Dimensions
Recommended Concrete
Pad Dimensions
800S Series
38"W x 144"L x 56"H
41 3/4"W x 147"L x 59 1/4"H
52"W x 158"L x 6" Thick
1000S Series
40"W x 174"L x 78"H
43 3/4"W x 177"L x 81 1/4"H
54"W x 188"L x 6" Thick
1000TS Series
40"W x 174"L x 90"H
43 3/4"W x 177"L x 93 1/4"H
54"W x 188"L x 6" Thick
1.
The concrete base should be 6” thick x 14” longer than enclosure ID x 14” wider than enclosure ID.
A.
Mark the concrete base for the outside of the enclosure (3” wider than ID and 3” longer than ID).
2.
The PVC masking film will help to protect the finish of the metal panels during installation. These
coatings should be left intact and removed only after assembly of the enclosure is complete.
A.
Assemble the “B-A-B” (side-end-side) assemblies using hex headed screws. (For best results, insert a
bead of silicone caulk into the inside bend of the “A” panel corners.) Position both sets of assembled
panels on the marked concrete base (Fig 2).
