Thank you for purchasing i3 International’s IP01P PoE extender (sold in pairs). Use IP01P as a point-to-point PoE (Power over
Ethernet) extender to power IP devices and to carry IP signal for distances of up to 328 feet (100 meters) using existing coaxial cable
infrastructure. Use with i3’s line of IP cameras and PoE switches.
INSTALLATION
PoE over Coax Extender, 300 ft
IP01P
User Manual
i3-TRNG-ACCESSORIES-
IP01P
.indd
Rev. 220913
FEATURES
• Signal extension up to 328 ft (100 m) over RG59/RG6U
coaxial cable.
• Power from a PoE switch or injector.
• Bandwidth up to 10Mbps.
• Use with i3’s PoE cameras and with i3 PoE switches.
*Note:
M79, Ax85, Ax19 are not supported.
PACKAGE CONTENTS
1.
IP01P x2 (one pair)
2.
Crossover cable x2 (8 in / 20 cm)
3.
Plastic Anchor x4
4.
Round Head Screw (Tapping Type) x4
PoE Cameras &
other IP devices
IP01P
i3 INTERNATIONAL INC.
1.866.840.0004
www.i3international.com
REGULATORY NOTICES (FCC CLASS A)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the
limits of a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
IP01P
328 ft
100 m
10 ft
3 m
10 ft
3 m
PoE Switch
CONNECTORS
1.
BNC Connector.
Connect to the second IP01P device
using the RG59 cable, 328 ft (100 m) or less.
The link speed is up to 10 Mbps.
2.
PoE Mode Selector Switch.
Pre-set to MID SPAN
setting (recommended).
See Tables 2, 3.
IMPORTANT:
Unplug power before switching between
MID SPAN and END SPAN modes to avoid damage.
3.
Power LED Indication.
Indicates device power status.
See Table 1.
4.
RJ45 Connector.
Connect one IP01P to the PoE IP
device and the other to PoE Switch. Do not exceed 10 ft
(3 m) cable run between IP01P and PoE equipment.
Figure 2.
IP01P front and back panels, parts description.
1
2
4
3
RJ45 straight connection
RJ45 straight connection
RG59 / RG6U coaxial
Figure 1.
IP01P connection diagram.
WARNING
Unplug power before switching between MID SPAN and END
SPAN modes to avoid damage to the device.
Figure 3.
IP01P front and back panels
