background image

users guide

Your Ideal users guide

ENGINEERED FOR PEACE OF MIND

When replacing any part on this appliance, use only spare parts that you can be 
assured conform to the safety and performance specification that we require. Do not 
use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers.

Harrier GTE

GTE 5, GTE 6, GTE 7, GTE 8 & GTE 9

9486 2082

Summary of Contents for Harrier GTE 5

Page 1: ...y part on this appliance use only spare parts that you can be assured conform to the safety and performance specification that we require Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers Harrier GTE GTE 5 GTE 6 GTE 7 GTE 8 GTE 9 9486 2082 ...

Page 2: ...istered for gas fired boilers Flammable materials must not be placed in close proximity to the appliance Materials giving off flammable vapours must not be stored in the same room as the appliance In cases of repeated or continuous shutdown a recognised installer CORGI registered for gas fired boilers should be called to investigate and rectify the condition causing this and carry out an operation...

Page 3: ...F operation For boilers fitted with high low burners a 2nd stage thermostat controls the burner changeover from high to low fire at a recommended setting 5ºC lower than the maximum flow temperature setting Note The setting numbers 3 9 are approximately scaled to represent 30 90ºC C 30 0 I 6A 4 1 3A 3B har7062 Standard Control Panel FD167 Deluxe Control Panel FD168 4 6 3A 3B 5 2 1 30 l 0 6A har7064...

Page 4: ...eating is detected by the overheat thermostat connected to the boiler control module If the boiler has overheated allow it to cool then press the safety thermostat reset button under the screw top cap 4 and the burner will relight If the fault recurs turn off the boiler and consult a recognised installer CORGI registered for gas fired boilers Escape of Gas Should a gas leak or fault be suspected c...

Reviews: