ARMING SYSTEM WHEN STAYING AT HOME
Wait for green ‘Ready’ light to come on
Press and hold down 5 key until you hear a beep
The armed Red light will come on.
ARMING WHEN LEAVING THE HOUSE
Wait for green ‘Ready’ light to come on
Press ‘#’ an enter your user code.
The red ‘Armed’ light will come on exit delay beeps should now begin, you may now
exit.
DISARMING
Enter your user code
Should you make a mistake press the hash Key (#) and re-enter your user code.
BYPASSING OF ZONES
Confirm panel is DISARMED
Press the [*] key (while bypassing zones, violated zones will be flashing0.
Press the number corresponding to the zone you need to bypass e.g. the [2] key if you
wish to bypass zone 2.
Repeat steps 1 and 2 to bypass any other zones.
OR
Confirm panel is DISARMED
Hold [9] till beep
Press the number corresponding to the zone you need to bypass then star [*], e.g. the
[2] key if you wish to bypass zone 2.
NOTE: Bypassed zones will be cleared when system is disarmed.
TROUBLE CONDITIONS
If the POWER LED is flashing (or if so programmed, the keypad is beeping) hold down the [7] key
for one second to see which zone indicator is on
Indicator
Trouble Condition
2
Failure to communicate to monitoring company
3
Mains power failure
4
Low battery
5
The telephone line has been cut or is not present
6
The siren wire has been cut or the fuse has blown
7
Keypad has experienced a tamper
8
Installers code must be entered to clear an alarm condition
Note: if the trouble has been fixed pressing the [#] key within 5 seconds of entering the
trouble view will clear the trouble condition indicator.
