CATEGORIA DE DOCUMENTO
TIPO DE DOCUMENTO
Preparado por / Prepared by
No. / Num.
Pág. / Page
Luis Vidaurreta
1 / 4
Aprobado por / Approved by
Fecha / Date
Rev./ Rev. Archivo / File
17/10/2017
PVTTR2400 installation
manual.docx
PVTTR2400-MCX INSTALLATION MANUAL
1.
SYSTEM DESCRIPTION
The module PVTTR2400-MCX has been designed and manufactured by IKUSI-Angel
Iglesias S.A. to be included in its radio remote control equipment.
The module PVTTR2400-MCX is a radio wireless for the frequency band 2405MHZ to
2475MHZ.
The module PVTTR2400-MCX is supplied with two smd antennas for antenna diversity.
2.
SAFETY INSTRUCTION
These instructions must be read carefully in order to install and use the set properly and to keep it in
perfect working condition and to reduce the risks of misuse.
Do not use this set on machines in potentially explosive atmospheres, except the models certified
ATEX/RATEX designed to work in that type of environments.
Any use other than that specified in this manual is dangerous. The following instructions must be
strictly adhered to.
4.1 - WHAT YOU MUST DO
Strictly adhere to the instructions for installation contained in this manual
Make sure that professional and competent personnel carry out the installation.
Ensure that all site and prevailing safety regulations are fully respected.
Make sure that this manual is permanently available to the operator and maintenance personnel.
Keep the transmitter out of reach of unauthorised personnel.
On starting each working day, check to make sure that the STOP button and other safety measures are
working.
When in doubt, press the STOP button.
Whenever several sets have been installed, make sure the transmitter you are going to use is the right
one. Identify the machine controlled on the label for this purpose on the transmitter.
Service the equipment periodically.
When carrying out repairs, only use spare parts supplied by IKUSI dealers.
4.2 - WHAT YOU MUST NOT DO
Never make any changes to the set, which have been studied and approved by manufacturer.
Never power the equipment other than with the specified power supply.
Never allow unqualified personnel to operate the equipment.
After use, never leave the equipment ON (one or several transmitters). Always set the contact key and
the STOP button to switch off position of the equipment to avoid accidentally to activate manoeuvres
–
specially in crane maintenance purposes-.
Do not use the set when visibility is limited.
Avoid knocking or dropping the set.
Do not use the set if failure is detected.
Changes or modifications not expressly approved by IKUSI could void the user
’s authority to operate this
equipment.
