background image

RCG01A

31A

RCG01A - GARAGE & GATE 

REMOTE PROGRAMMING

The following procedure is for programming a RCG01A remote to your garage roller door:

On the receiver board locate 

the ‘S1’ or ‘Learn’ programming 

button. It will be situated next to 

the courtesy light globe and a 

red LED.

Press and release the 

‘S1’ or ‘Learn’ programming 

button once, the red LED 

should light up. You are now 

in programming mode.

Press and release button 1 

on your new remote once.

If programming is successful, 

the red LED will turn off. 

Replace the cover and test 

your new remote at the unit to 

confirm.

Locate the receiver board on 

the internal circuit board.

1

2

6

7

8

3

4

5

Reach under the bottom to 

release the locking clip.

Lift the cover off to reveal the 

internal circuit board.

Identify your receiver unit. 

Caution: Do not touch any other buttons or components other than what is stated to do so in the below procedure. 

Reviews: