Q
uick
Start
Guide
Primor
development kit
I N F I T E C
Excellence in 3D
®
Kit Layout
2 x Plastic Attachment
2 x Filter (Left and Right)
2 x Metal Attachment
Metal attachments for filters
Installation
For installation of the Primor development kit
you need the following:
1) Dual projectors (preferably same brand and model)
2) Marker (for marking the outline on projector)
3) Primor development kit
Primor development kit is provided with
1) Red glue points
2) White glue strips
There are many ways to perform this installation and
below is a sample way to do it. You can be creative
depending on your projector model.
1) There are 2 types of glue solutions provided:
Red glue points: It is a permanent glue point. Use it if
you want to have a permanent installation.
White glue strips: It is a temporary glue strip and can
be removed easily.
Note:
We suggest using the white glue strips as it is easy
to use and if in case there is a mistake then it is easy to
remove without causing any damage to the surface of the
projector.
2) Don’t remove the glue points yet and try to fix the
primor kit on either projector in such a way that
the filter is on front of the projector. Then use the marker
to mark the both sides to get a rough idea where the
projector will be placed as shown in below pictures.
3) After marking, remove the other side of the glue paper
then place the filter on the markings. If the position is wrong
then remove the glue markings and repeat step 2. The
final result should look something like below. Although
it may differ based on your mounting.
4) Repeat the steps 2 and 3 for mounting of second projector.
The final Installation should look more or less as on picture
provided on next page. You can use your own way of stacking
the projectors
