Ingersoll-Rand 7P24L-EU, Instructions Manual

Refer All Communications to the Nearest
Ingersoll–Rand Office or Distributor.



 Ingersoll–Rand Company 2000

Printed in U.S.A.

03529385

Form P6612–EU
Edition 10
August, 2000

INSTRUCTIONS FOR

MODELS 7S30L–EU, 7S48L–EU

 AND 7S60L–EU SANDERS AND

MODEL 7P24L–EU POLISHER

Models 7S30L–EU, 7S48L–EU and 7S60L–EU Sanders and 7P24L–EU Polisher are designed for
standard duty sanding and polishing operations in automobile repair shops and in sheet metal
fabrication applications.

Ingersoll–Rand is not responsible for customer modification of tools for applications on which
Ingersoll–Rand was not consulted.

IMPORTANT SAFETY INFORMATION ENCLOSED.

READ THIS MANUAL BEFORE OPERATING TOOL.

IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE

INFORMATION IN THIS MANUAL INTO THE HANDS OF THE OPERATOR.

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

PLACING TOOL IN SERVICE

•

Always operate, inspect and maintain this tool in
accordance with all regulations (local, state, federal
and country), that may apply to hand held/hand
operated pneumatic tools.

•

For safety, top performance, and maximum
durability of parts, operate this tool at 90 psig 
(6.2 bar/620 kPa) maximum air pressure at the inlet
with 5/16” (8 mm) inside diameter air supply hose.

•

Always turn off the air supply and disconnect the
air supply hose before installing, removing or
adjusting any accessory on this tool, or before
performing any maintenance on this tool.

•

Do not use damaged, frayed or deteriorated air
hoses and fittings.

•

Be sure all hoses and fittings are the correct size
and are tightly secured.  See Dwg. TPD905–1 for a
typical piping arrangement.

•

Always use clean, dry air at 90 psig maximum air
pressure.  Dust, corrosive fumes and/or excessive
moisture can ruin the motor of an air tool.

•

Do not lubricate tools with flammable or volatile
liquids such as kerosene, diesel or jet fuel.

•

Do not remove any labels. Replace any damaged
label.

USING THE TOOL

•

Always wear eye protection when operating or
performing maintenance on this tool.

•

Always wear hearing protection when operating
this tool.

•

Keep hands, loose clothing and long hair away from
rotating end of tool.

•

Anticipate and be alert for sudden changes in
motion during start up and operation of any power
tool.

•

Keep body stance balanced and firm.  Do not
overreach when operating this tool.  High reaction
torques can occur at or below the recommended air
pressure.

•

Check for excessive speed and  vibration before
operating.

•

Tool shaft may continue to rotate briefly after
throttle is released.

•

Air powered tools can vibrate in use.  Vibration,
repetitive motions or uncomfortable positions may
be harmful to your hands and arms.  Stop using any
tool if discomfort, tingling feeling or pain occurs.
Seek medical advice before resuming use.

•

Use accessories recommended by Ingersoll–Rand.

•

This tool is not designed for working in explosive
atmospheres.

•

This tool is not insulated against electric shock.

The use of other than genuine Ingersoll–Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.

Repairs should be made only by authorized trained personnel.  Consult your nearest Ingersoll–Rand Authorized
Servicenter.

GB

TPD1380