INSTALLATION INSTRUCTIONS FOR RU–SERIES
RETROFIT EXTRA HEAVY DUTY UNIT LEVER LOCKSET
IMPORTANT:
THIS LOCK IS FOR 1-3/4” (45MM) THICK DOORS ONLY.
THE LOCK IS FACTORY HANDED FOR USE ON RIGHT HAND (RH) OR LEFT HAND (LH) DOORS. SEE
STEP 9 FOR
FIELD REVERSING
THE LOCK TO RHR OR LHR DOORS. FOR FUNCTIONS RU371, RU381,
RU561 & RU571, SEE STEP 14 FOR STD CYLINDER & STEP 15 FOR IC CORE TIMING INSTRUCTIONS.
STEP 1
EXAMINE DOOR PREPARATION AND HANDING
These instructions are applicable to the two most common door prepa-
rations – Yale Mono Lock and Corbin Russwin Unilock – as shown in
the illustration on the right. If your door preparation is different,
S
TOP
!
You need to contact the factory for instructions speci
fi
cally for your
door preparation.
STOP!
Ensure that the lock handing matches the door handing and
bevel. If it does not match, refer to Step 9 before continuing.
Outer Trim Assembly
Interchangeable Core Cylinder
Set Screw
1/4-20 x 1/4”
Mounting Screws
#10-32 x 1”
Flange Nut
Inner Lever
Rose
Inner Trim
Assembly
Latch Mounting Screws
#8-32 x 1/2”
Inner Mounting
Plate
Chassis Assembly
Latch Assembly
Outer Trim Assembly
Standard Cylinder
LEFT HAND REVERSE SHOWN
OUTSIDE
INSIDE
INSIDE
OUTSIDE
DOOR HANDS DETERMINED FROM OUTSIDE
LEFT
HAND
RIGHT
HAND
LEFT
HAND REVERSE
RIGHT
HAND REVERSE
1
1-1/4”
1
3-1/2”
2
3-5/8”
1
2
CL
of Door
Low Side of Bevel
Beveled
1/8” in 2”
2-3/4”
Backset
7/16” Thru
2 Plcs
1
5/32” Dia
1
Applies to Yale Mono Lock
2
Applies to Corbin Russwin Unilock
1-1/4”
1-3/4”
2-1/2”
03153400070
