InnoMedia
IP Phone 6308SL
Quick Install Guide
Introduction
The InnoMedia IP Phone 6308SL is an integrated device providing
telephony service over a broadband network. This guide will help
you to quickly install and configure your unit so that you can start
placing calls right away.
Package Contents
The InnoMedia IP Phone 6308SL comes with the following items:
1 IP Phone 6308SL
1 AC/DC Power Adapter
1 Ethernet Cable
1 Quick Install Guide
Note: Make sure you have received above items in the Package. If
anything is missing, please contact your network service provider.
Appendix A. LED Status Summary
LED
Blinking State
Description
Any LINE
Key
Off
The line has not been enabled or is not setup
Green Steady
The line has successfully registered to the server and
is available for use
Amber Steady
The line is not registered and is not available for use
Green Blinking (.5 sec
ON, .5 sec OFF)
The line is ringing with an incoming call
Green Blinking (1 sec
ON, 1 sec OFF)
The line has a voicemail message waiting
Red Steady
The line is being actively used
Red Blinking (.5 sec
ON, .5 sec OFF)
The line is on HOLD
SPEAKER
Green Steady
Speakerphone is in use
Off
Speakerphone is not in use
VMWI
Red Steady
New voicemail is waiting
Off
No new voicemail
Specifications
Network Interface
Dual 10/100 Base-T Uplink/Downlink
PoE 802.11af
Display Interface
4 line character-based LCD Display
Visual Message Waiting Indicator (VMWI)
Dimension
2.14 in (H) x 6.10 in (W) x 8.12 in (D)
72 mm x 180 mm x 220 mm
Power Supply
Input: AC 100-240V, 1.0A max., 50-60Hz
Output: DC 12V, 1.0A
Power Consumption
Talk: DC 12V @ 0.26Amps (3.12W)
Idle: DC 12V @ 0.18 Amps (2.16W)
Weight
Weight: 1.64 lbs (744g)
www.innomedia.com
© 2008 InnoMedia, Inc. All rights reserved. InnoMedia and the InnoMedia logo are trademarks of InnoMedia, Inc. All other
brand and product names may be trademarks of their respective companies.
Version 1.2; 03-09
FINDING A CONTACT
You can view the contents of the phonebook , and also dial a con-
tact directly from the phonebook.
1. Press the DIRECTORY button
2. Select 3. Browse, then press Enter
3. Press the >> button to browse the phonebook entries
4. Once you have found the contact you wish to call, press CALL to
connect to them
Troubleshooting
Problem:
I have no dial tone
Solution:
Your unit may not have successfully connected to the network.
1. Unplug the power of the unit
2. Check to make sure you connected the Ethernet cable from
your broadband modem to the WAN port on the back of the IP
Phone
3. Plug in the power of the unit and wait for a few seconds while
it initializes
4. When LED light stays solid green, you may try again to make a
phone call
Please contact the service provider if you are still having a problem
receiving dialtone.
*Picture shown is the IP Phone 6308SL
