To ensure the batteries are kept in good condition,
always put the hoist on charge after use. Never allow
the battery to fully discharge.
Charging
To ensure a long service life of the batteries, please ensure
that the hoist is left on charge when not in use.
To charge the
AirRise
200
™
, follow the following procedure:
•
Place the hand control in the wall charger (Figure 1)
•
Check if the indicator light lights up (Figure 2)
•
Leave hoist on charge for about 8 hours.
Figure 1:
The wall charger
Figure 2:
Charging indicator light
Hand Control
The plug of the hand control should be placed firmly in the input at the bottom of the
lift. The cord of the hand control can, if requested, be fitted with a strain release or
fixed with screw-thread.
Top 2 buttons:
These control the hoist’s lifting and
lowering
Middle 2 buttons:
If the hoist is fitted with a electrically
powered spreader bar, these buttons enable
this to be used.
Indicator light:
In the middle of the letter ‘O’ in INNOVA™, there
is an LED indicator light. This tells you when the
hoist is charging.
Bottom 2 buttons:
Turn the hoist on and off. When charging, the LED
indicators light up at the bottom of the hoist. Should
this be annoying, for example in a bedroom, this can be
turned off with the red button. There is also the option of a
bedroom mode, with which the charging indicators switch
off automatically after 2 minutes.
The
most innovative
healthcare equipment in the world.
t
|
0345 034 1450
f
|
0345 034 1451
e
|
enquiries@innova.uk.com
www.innovacareconcepts.com
Quick User Guide
