REV. 02/26/2020 PN:
PG:1
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on pool step.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
WARNING
Install the step on a flat surface.
Do not jump or dive from the step.
Remove the step from water when temperatures drop below freezing.
In winter, the step should be stored in an area protected from snow.
Never lift the step by its handrails.
Use BATTERY operated tools to avoid electric shock near water.
Ensure no corrosive materials are added to the step or harware kit.
The step must be installed per manufacturer’s instructions.
File off all stripped or sharp edges before assembly to avoid injuries
and liner damage.
The manufacturer is not responsible for damages or injuries caused
by improper installation or use of product.
To ease the installation of handrails and bolts, use a screwdriver to
line up the holes.
BILTMOR DECK 5050
Required tools
(not included)
A
2X
GUSSET
INSERT NUT
1)
Insert the two gussets in the slots and slide them
toward the corners.
2)
Assemble the two main modules with the six screws,
nuts and washers provided.
3)
Snap the door between the top and bottom module
within the slots provided.
Contents of the Biltmor box SKU # 5050
x4
x2
x2
x4
x2
x2
Contents Riser kit
x2
Sand
(not included)
Sand
5 lbs
x6 x6 x6
A B C
Phillips #2
Phillips #3
7/16 wrench
Phillips bit
x2
x4
x2
(3/4 IN.)
x4
D
SCREW BAG 140-0067
x6 x6 x6
(1 IN.)
(1
¹⁄2
IN.)
(
³⁄4
IN.)
x2
(
³⁄4
IN.)
x24
x12
A B C D E F
SCREW BAG 140-0010
