BCI Mfg Inc P.O. Box 1207 North Plains, OR 97133 info@insideride.com
Core E-flex Assembly
The E-flex rear base connects to the Core trainer
Here is the Core E-flex base as viewed from the
back.
Lay the Core on a table or countertop with the flywheel facing down. Hang
the legs of the core over the table edge. Remove the two support bars from
the Core receivers. They each have two bolts. You’ll need to pry off the
plastic caps to get access
to the nuts underneath.
The E-flex base will
attach at these same
points.
The Core is now ready to
receive the E-flex base in
the orientation shown.
There are two connectors
on the E-flex base that fit
into the Core receivers.
Front
Before
After
Before
Forward Connector
