Instant Promotion
(UK) Ltd
Unit 7, Liberty Industrial Park, South Liberty Lane, Bristol, BS3 2SU | Tel: 0117 963 1668 | www.instantpromotion.co.uk
01
02
03
04
05
06
07
08
09
10
11
12
For more detailed instructions on how to use the pump, please refer to page 3.
Lay out the setup groundsheet, remove the
contents from the bag and roll out the spider
dome in a semi-circular shape as pictured.
Locate a valve in one of the legs and unscrew the
valve cap. If you have two valves on your unit,
ensure the other valve is closed for inflation.
Set the pump to the inflate setting with the
inflate/deflate nozzle attached.
Insert the nozzle into the valve and twist
clockwise to lock into position. Turn the
pump on.
Once the dome is pressurised to about 80% air
pressure, turn off the pump and close the valve.
Move to the opposite side of the dome, and with
two people on the outside, pull the remaining
two legs out until the dome is stood upright.
Using the top up function on the pump, fully
pressurise the spider dome to give full structural
integrity. A second person should hold the
dome throughout inflation.
Turn off the pump and close the outer cap on
the valve.
Insert weight plates into the zip pockets
located at the base of each leg.
When possible, secure the dome to the ground
using pegs through the D-rings on each leg.
If you have walls, locate the zip and attach to
the dome. Zip up until the wall is fully attached
to the unit and repeat with any other walls.
Remove the groundsheet from under the unit
and setup is complete.
01.
02.
03.
04.
05.
06.
07.
08
09.
10.
11.
12.
Spider Dome Pro Setup Guide
