Part No 1013153
1
Floor Base and Fixed Trapeze
For more information regarding Invacare products, parts, and services, please visit www.invacare.com
Floor Base and Fixed Trapeze
Model Nos. 7714P and G7740P
NOTE:
Check
ALL
parts
for
shipping
damage.
In
case
of
shipping
damage,
DO
NOT
use.
Contact
Dealer/Carrier
for
further
instructions.
Safety Summary
To
ensure
the
safe
and
proper
installation
of
the
Floor
Base
and
Fixed
Trapeze,
these
instructions
MUST
be
followed:
WARNING
DO NOT install this equipment without first reading and understanding this instruction sheet. If
you are unable to understand the warnings, cautions and instructions, contact a healthcare
professional, dealer or technical personnel if applicable, before attempting to install this
equipment - otherwise, injury or damage may occur.
The Fixed Trapeze MUST ONLY be installed onto beds with metal framed headboa
rds.
The Fixed Trapeze used in conjunction with a bed, can assist an individual weighing up to 250 lbs.
(114 kg.). The Fixed Trapeze is designed to provide support, increase stability and assist the user
when repositioning himself/herself in bed.
Use the trapeze as an assistive device only. The trapeze is not designed to support the total body
weight of an individual or to be used as an assist device when transferring into or out of a bed.
INSTALLATION WARNINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching
component parts are secure.
DO NOT INSTALL OR ADJUST TRAPEZE OF AN OCCUPIED BED.
DO NOT attach swivel trapezes to the floor base. This may cause the floor base to tip over,
causing injury to the patient and/or assistants.
Floor Base MUST be positioned under the bed at the headboard position.
Ensure that the snap buttons fully protrude through the adjustment hole of the floor leg
assembly. This ensures that the Floor Base is properly installed and securely locked in position.
ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in conjunction with
Invacare accessories. Accessories designed by other manufacturers have not been tested by
Invacare and are not recommended for use with Invacare products.
Assembling the Floor Base
NOTE:
For
this
procedure,
refer
to
FIGURE 1
on
page 2.
1.
Install
the
ʺ
A
ʺ
frame
into
the
floor
base
assembly
with
the
snap
buttons
facing
the
short
length
of
the
floor
base.
2.
Depress
the
snap
button
on
one
leg
of
the
ʺ
A
ʺ
frame
and
slide
it
into
the
floor
base
assembly
until
an
audible
ʺ
click
ʺ
is
heard.
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
