Model CV-6348PR
Piezo Proximity Reader Plus 8 Bit Keypad
Installation Instructions
OPERATION MODES:
Output formats:
Card output: Wiegand, PIN output:
8 Bit Burst
Power Supply:
5 to 12 VDC
Power Consumption:
Max 150 mA
Transmitter/Receiver frequency:
125Khz
Mounting:
Universal (single gang box)
Environment:
IP68 ; 100% relative humidity
Operating Temperature:
- 20 to + 70ºC
Dimensions:
120 x 90 x 20 mm (4.72” x 3.54” x .79”)
Anti-tamper Optical protection
Certifications:
Complies with FCC Part 15
Model CV-6348PR is equipped with 2 electronically
interlocked devices. The Proximity Reader and the
Piezoelectric Keypad.
This keypad supports the following operation modes:
1.
Prox – Pin.
Present Prox card. The unit will read the
content and send it over the Data wires to the host.
Enter PIN code. The unit will send each digit over the
same Data wires to the host. The Keypad and the Prox
reader are interlocked so that when one is functioning
the other is inhibited until the data is transmitted.
2.
Prox Only.
The prox electronics is independently
communicating via Data wires.
Verification
Apply power to the unit. During the first 5 seconds it is possible
to reprogram the Site code (see instructions). The unit will
activate the buzzer and the Yellow LED 3 times. At the same
time the RED or the Green LED will come ON depending on
the Central Computer setup. Present a valid HID encrypted
card at 5 cm (2”) distance maximum. The unit will activate
the Buzzer and the Yellow Led once.
Enter any combination of PIN code up to 65534. The unit will
activate the Buzzer and the Yellow Led with each pressed key.
COLOR
FUNCTION
ELECTRICAL FUNCTION
RED
Input Voltage
5 to 12 VDC
BLACK
Ground
GREEN
Data 0
Open collector 1Kohm pull-up to in5V
WHITE
Data 1
Open collector 1Kohm pull-up to in5V
BROWN
LED Input
No Voltage
BLUE
CCTV output
Open collector 0,250 A activated with
each key for 30 sec
VIOLET
Housing Ground
ORANGE
Buffered Input
GREY
Tamper Output
Open collector 0,100 A “Low” when light sensed
Wiring
