iPower TPD-800A Quick Installation Manual Download

Page: 1 / 6

iPOWER TPD-800A Quick Installation Guide

TPD-800A Quick Installation Guide

This Quick Installation Guide is a basic introduction of the TPD-800A hardware and software configuration.

It is provided with the hope of helping you to configure the device fast and easily. For more detailed

information, please refer to the User Manual.

Ⅰ

. Hardware Configuration

1. Checking the devices and accessories first, one set of TPD-800A and one piece of network cable.

2. Set up the TPD-800A as Master. (M/S indicator on means the TPD-800A is Master, M/S indicator off

means the TPD-800A is slave).

Master Setting Method: Press Reset button on the device for 12 seconds (the interval of RUN light is 2

seconds) Setting is successful when the M/S indicator is on.

Slave Setting Method: Press Reset button on the device for 6 seconds (the interval of RUN light is 2 seconds.

Setting is successful when he M/S indicator is off.

Summary of Contents for TPD-800A

Page 3: ...nged PC IP address and the default device IP address are in the same network segment For instance set the PC IP address to be 192 168 1 X X can be 0 to 255 except 163 the Sub net Mask 255 255 255 0 the default gateway 192 168 1 1 As shown in the following 3 Log on to the user administration interface through IP 192 168 1 163 with the default login name and password ...

Page 4: ...WER TPD 800A Quick Installation Guide 3 Click on and open the Device Configuration interface enter the device series number that is a unique one which could be viewed on the LED screen of the device panel ...

Page 6: ...OWER TPD 800A Quick Installation Guide 7 Connect TPD 800A and PC to WAN and access TPD 800A with the new IP configured TPD 800A also support SNMP SSH and Telnet management Details refer to the User Manual ...