ID
Mobile/RFID Reader
(IRD2M)
Installation Guide
Version 1.0.0
Safety instructions
Observe the following instructions to use the product safely and prevent any risk of injury or property damage.
Warning
Noncompliance of instructions could lead to serious injury or death.
Installation
Do not install the product in a place with direct sunlight, moisture, dust, or soot. A fire or electric shock may
occur.
Do not install the product in a place with heat from an electric heater. A fire or electric shock may occur due to
overheating.
Install the product in a dry place. Otherwise, a product damage or electric shock may occur due to moisture.
The user should not install or repair the product independently. If the product has been damaged due to
independent installation or repair of the product by the user, free A/S service will not be provided.
Caution
Noncompliance of instructions could lead to minor injury or product damage.
Operation
Do not allow liquids such as water, beverages, or chemicals get into the product. A fire, electric shock, or
product damage may occur.
Installation
Do not install the power supply cable in a place where people pass by. Product damage or physical injury may
occur.
Do not install the product near a highly magnetic object such as a magnet, TV, (especially CRT) monitor, or
speaker. A product failure may occur.
If installing the product outside where the product is completely exposed, it is recommended to install the
product together with the enclosure.
Keep the minimum separation distances between the devices when install multiple devices. Otherwise, RF
performance is affected to the other device, the devices may not operate normally
